C1000-002 Exam Dumps - IBM MQ V9.0 System Administration

C1000-002 IBM MQ V9.0 System Administration exam is a test for IBM Certified System Administrator - MQ V9.0 certification, its previous exam C9530-510 was retired. Through IBM C1000-002 Exam Dumpsprovided by Passcert, we can ensure you have a successful challenge when you are the first time to participate in the IBM certification C1000-002 exam.

C1000-002 Exam Overview - IBM MQ V9.0 System Administration

IBM Certified System Administrator - MQ V9.0 certification is for system administrators who have extensive product knowledge and are expected to plan, install, configure and maintain the product.To attain the IBM Certified System Administrator - MQ V9.0 certification, candidates must pass C1000-002 - IBM MQ V9.0 System Administration test.

C1000-002 Exam Objectives Described Below.

Section 1 - Planning, Installation, and Migration     14%

Section 2 - Configuration        17%

Section 3 - Security      14%

Section 4 - Administration    15%

Section 5 - Availability        9%

Section 6 - Monitoring         9%

Section 7 - Performance Tuning       8%

Section 8 - Problem Determination     14%

Free Share IBM C1000-002 Exam Dumps Free Demo:

1.After completing an IBM MQ for z/OS installation and customization, how can a successful installation be verified?

A. Review the z/OS MQ SMF records.

B. Run the command runmqsc -installation_verify.

C. Put a test message on a newly created z/OS queue.

D. Use the MQ for z/OS installation verification programs (IVPs).

Answer: D

2.For MQ Advanced for distributed platforms, which two components are included? (Select two.)

A. MQ Appliance

B. Managed File Transfer

C. MessageSight

D. IBM MQ Internet Pass-Thru

E. Advanced Message Security

Answer: BE

3.An administrator is asked to forward all messages to queue ‘TEST.TEMP’ if the messages destined for ‘TEST.LOCAL’ end up on the dead letter queue.

Which rule in the dead letter handler rules table will enable the administrator to achieve this objective?

A. REASON(MQRC_Q_FULL) ACTION(FWD) FWDQ(&DESTQ) HEADER(NO)

B. REASON(*) ACTION(FWD) FWDQ(‘TEST.TEMP’) HEADER(NO) DESTQ(‘TEST.LOCAL’)

C. REASON(*) ACTION(RETRY) FWDQ(‘TEST.LOCAL’) HEADER(NO) INPUTQ(‘TEST.TEMP’)

D. REASON(MQRC_Q_FULL) ACTION(IGNORE) FWDQ(‘TEST.TEMP’) HEADER(NO) DESTQ (‘TEST.LOCAL’)

Answer: A

4.What is the purpose of the –s secretText parameter used in the prepareha and crthagrp commands on MQ Appliance?

A. To be used as the unique key for the appliances.

B. To be used to decide. In secret, which appliance will be the preferred appliance.

C. To generate a short-lived password used to create two keys, one for each appliance.

D. To generate a short-lived password used to set up on unique key for the appliances.

Answer: A

5.Which channel may be configured with a channel auto-definition exit?

A. Sender Channel

B. Receiver Channel

C. Requester Channel

D. Client-Connection Channel

Answer: A